Cisco 500-006 Exam Actual Questions

The questions for 500-006 were last updated on July 7, 2024.

Viewing page 1 out of 20 pages.
Viewing questions 1-4 out of 77 questions

Topic 1 - Single Topic

Question #1 Topic 1

Which Cisco TelePresence C Series Codec command will move the on-screen display to monitor output 4?

A. configuration video osd output: 4
B. xconfiguration video osd output: 4
C. command video osd output: 4
D. xcommand video osd output: 4

Reveal Solution Discussion

Correct Answer: B 🗳️
TC 7.2 Admin Guide -

Question #2 Topic 1

Which menu on the Cisco TelePresence VCS should you refer to in order to verify that an endpoint has registered?

A. Application
B. Status
C. Security
D. Configuration

Reveal Solution Discussion

Correct Answer: B 🗳️
X8.2 Admin Guide -

Question #3 Topic 1

After you change the IP address of a Cisco TelePresence Codec C90, you are unable to use Telnet or a browser to connect to that address. However, you are able to use ping to connect to the new address. What are the two possible causes? (Choose two.)

A. The configuration failed and there is another device with the same address that responds to the ping.
B. The codec disabled the Telnet and HTTP services after the IP address change.
C. The codec needs to reboot after the IP address change in order to bind the services to the new address.
D. The gatekeeper configuration failed and you need to set up the gatekeeper address and the discovery type again.

Reveal Solution Discussion

Correct Answer: AC 🗳️

Question #4 Topic 1

The camera remote control is not responding. What can an engineer check in order to determine if the camera remote control or the system is causing the problem?