Juniper JN0-664 Exam Actual Questions

The questions for JN0-664 were last updated on July 3, 2024.

Viewing page 1 out of 24 pages.
Viewing questions 1-4 out of 96 questions

Topic 1 - Exam A

Question #1 Topic 1

Click the Exhibit button.

R2 is receiving the same route from R1 and R3. You must ensure that you can load balance traffic for that route.
Referring to the exhibit, which configuration change will allow load balancing?

A. Configure the multipath parameter under the global BGP configuration.
B. Apply the prepend policy as an import policy under group R1.
C. Configure the multipath multiple-as parameter under the global BGP configuration.
D. Apply the prepend policy as an import policy under group R3.

Reveal Solution Discussion 2

Correct Answer: C 🗳️

Question #2 Topic 1

Click the Exhibit button.

You are troubleshooting the connection between AS 64496 and AS 64497 and notice that only one of the paths is being used for traffic forwarding.
Referring to the exhibit, which three actions will ensure that R1 is configured properly for load balancing BGP routes? (Choose three.)

A. Verify that the routing table on R1 has BGP routes for 203.0.113.128/25 with multiple next hops.
B. Verify that the multipath option is configured under protocols bgp on both R2 and R3.
C. Verify that there is a load balancing export policy under routing-options for the received BGP routes on R1.
D. Verify that the multipath option is configured under protocols bgp on R1.
E. Verify that an import load balancing policy exists under protocols bgp for the received BGP routes on R1.

Reveal Solution Discussion 5

Correct Answer: ABD 🗳️

Question #3 Topic 1

After a recent power outage, your manager asks you to investigate ways to automatically reduce the impact caused by suboptimal routing in your OSPF and OSPFv3 network after devices reboot.
Which three configuration statements accomplish this task? (Choose three.)

A. set protocols ospf3 realm ipv4-unicast overload timeout 900
B. set protocols ospf overload
C. set protocols ospf overload timeout 900
D. set protocols ospf3 overload
E. set protocols ospf3 overload timeout 900

Reveal Solution Discussion 6

Correct Answer: CDE 🗳️

Question #4 Topic 1

You are configuring anycast RP for load balancing and redundancy in your PIM-SM domain. You want to share active sources between RPs.
In this scenario, what are two solutions that will accomplish this task? (Choose two.)

A. Configure MSDP on each RP router.
B. Configure anycast PIM with the rp-set statement on each RP router.
C. Configure anycast PIM with the rp-set statement on each source DR router.
D. Configure MSDP on each source DR router.

Reveal Solution Discussion 4

Correct Answer: AB 🗳️

Juniper JN0-664 Exam Actual Questions

The questions for JN0-664 were last updated on July 3, 2024.

Topic 1 - Exam A

Get IT Certification

New Version GCP Professional Cloud Architect Certificate & Helpful Information

The 5 Most In-Demand Project Management Certifications of 2019